int xPin = A0;
int yPin = A1;
int buttonPin = 2;

int xPosition = 0;
int yPosition = 0;
int buttonState = 0;

void setup() {
  // initialize serial communications at 9600 bps:
  Serial.begin(9600); 
  
  pinMode(xPin, INPUT);
  pinMode(yPin, INPUT);

  pinMode(3, OUTPUT);
  digitalWrite(3, LOW);
  pinMode(4, OUTPUT);
  digitalWrite(4, LOW); 
  pinMode(5, OUTPUT);
  digitalWrite(5, LOW); 
  pinMode(6, OUTPUT);
  digitalWrite(7, LOW); 
  pinMode(7, OUTPUT);
  //activate pull-up resistor on the push-button pin
  pinMode(buttonPin, INPUT_PULLUP); 
  
  // For versions prior to Arduino 1.0.1
  // pinMode(buttonPin, INPUT);
  // digitalWrite(buttonPin, HIGH);
  
}

void loop() {
  xPosition = analogRead(xPin);
  yPosition = analogRead(yPin);
  buttonState = digitalRead(buttonPin);
  
  //Serial.print("X: ");
  //Serial.print(xPosition);
  //Serial.print(" | Y: ");
  //Serial.print(yPosition);
  //Serial.print(" | Button: ");
  //Serial.println(buttonState);

  if (buttonState == 0) {
    Serial.println("pressed");
    digitalWrite(3,HIGH);
    delay(100);
    digitalWrite(3,LOW);
    delay(500);
  }
  if (xPosition < 400) {
    Serial.println("x <<< ");
    digitalWrite(4,HIGH);
    delay(100);
    digitalWrite(4,LOW);
    //delay(500);
  }
  if (xPosition > 600) {
    Serial.println("x >>> ");
    digitalWrite(5,HIGH);
    delay(100);
    digitalWrite(5,LOW);
    //delay(500);
  }
  
  if (yPosition < 400) {
    Serial.println("y <<< ");
    digitalWrite(6,HIGH);
    delay(100);
    digitalWrite(6,LOW);
    //delay(500);
  }
  if (yPosition > 600) {
    Serial.println("y >>> ");
    digitalWrite(7,HIGH);
    delay(100);
    digitalWrite(7,LOW);
    //delay(500);
  }
  delay(50); // add some delay between reads
}